The error message "db::exception: table is in readonly mode (replica path:...)" suggests that the database table you are trying to write to is currently set to read-only. This typically occurs when the table is a replica or a secondary copy of data for backup, disaster recovery, or load balancing purposes. In distributed databases or replication setups, replicas usually don't allow write operations to maintain data consistency and avoid conflicts with the primary/master database. To resolve this issue: 1. Check the Database Configuration: Ensure that you are connecting to the right instance of your database - i.e., the primary or writable instance rather than a read-only replica. 2. Switch Write Operations to Primary: If you need to perform write operations, they should be directed to the primary/master database. 3. Change Replica Mode: If it's necessary to make changes on the replica temporarily, you would need to disable the read-only mode according to your database management system's guidelines. However, this is generally not recommended unless there's a specific maintenance scenario where the primary is unavailable. 4. Maintenance Tasks: If you're performing maintenance or backup tasks and the readonly status is expected, then you'll need to adjust your script or process to avoid writing to this specific table or database. 5. Database Recovery/Replication Issue: If the issue arises unexpectedly, check the health of your replication setup. There could be an issue causing the replica to go into read-only mode. Please refer to your database system's documentation for specific steps on how to manage and configure replication settings or switch between read-write and read-only modes. [2024-03-05 17:36:43 | AI写代码神器 | 326点数解答]